I am so glad you liked my FBA tutorial for the Anna dress 🙂 (And I am glad you realised how much effort it was; I took photos as I went along, but it wasn’t until I was editting them that I realised how many steps there were!)
I have sewn my bodice muslin (well in a cheap fabric that I will use for first wearable test version) and realised the gathers I have are a bit too big to be flattering. Do you remember my Cambie dresses? I had the same problem there; with a full bust, the size of darts/gathers is big, so the darts begin to make a pointy corner. And how did I solve that problem? I changed the darts from one to three, so each dart was slightly smaller and less pointy!
Here is a quick diagram to show the extremely scientific method I used to adjust the gathers on my Anna (after unpicking the first set). Following my FBA tutorial, work your way to step 20, and stop there.
Changing gathers is easier than changing darts, as you don’t have to worry about the pointy dart ends. For my measurements I narrowed each pleat by about an inch (technically it was a thumbnail length). I then created a new pleat in between (green lines), making sure it was the same size as the amount I removed (2 red lines below). This gave me 3 approximately equal pleats, but you could measure them and do some maths (if you haven’t spent all day teaching 4 year olds how to sit quietly! this method is good enough for me!)
And here is how the pleats now look in real life:
Dodgy camera-phone shots in the mirror, but I think you can see the effect. I have pinned and re-sewn the pleats more than my fabric could cope with, so I need to cut out a new bodice before I can carry on with the sewalong. Who else is sewing along? How is it going?